Install CortexClient
Go to the AVUTEC partner portal:
Password: Avutec!
You will find CortexClient.exe within the application tab.
Start CortexClient and login:
Username: administrator
Password: cortex
If the camera is powered through PoE+ and your PC is in the same network, the camera (GUID) should pop up underneath discovery (see below screenshot).
If not login via CortexConnect (see in below screenshot) with your personal login credentials.
Login into the camera by clicking the arrow next to the camera (see yellow arrow in the screenshot below).
The pop up for the log in credentials will appear.
username: administrator
password: cortex
Check the "Remember me" box for easy login next time
Underneath the GUID (serial number of the camera), the camera application, in AVUTEC terms the Cortex, will become visible.
In this case the Cortex is named GatekeeperX4 (see below screen shot)
If a Module is installed all steps will be the same. The Cortex will be named ModuleX.
Normally the Cortex is running.
If not click right on the Cortex and choose "run".
When the Cortex is running, double click the Cortex called GatekeeperX4.
The settings of the camera will open.
In the bottom right corner, the settingspanel of the GatekeeperAxon is located.
Choose the tab Wiegand and enable it (see below screenshot)
Then choose the tab Card data and set:
Card format: 26 bit hashing
Send using Wiegand: enable
All is set.
